Luvocom® 3F PAHT 9825 NT Filament

photo_luvocom_3f_paht_9825_nt_filament_3d_printing
€ 90,69 (€ 74,95 excl. BTW) stuk
Gewicht: 0.75 kg

Filament diameter
Gewicht

Aan winkelwagen toevoegen Aan verlanglijst toevoegen

Luvocom® 3F PAHT 9825 NT Filament

Description

Luvocom® 3F PAHT 9825 NT Filament is a unreinforced High-temperature polyamide. Its water uptake takes about 4 times longer to reach the saturation point compared to unmodified PA6, also its saturation point is 5 times lower than conventional PA6 materials. This particular engineering polymer grade is tailored made for the 3D printing industry to match the injection molding strength requirements and focusing on the serial production of end-parts. The filament can be used on conventional FFF / FDM 3D printing systems due to the enhanced printability, improved layer bonding and the unrequired use of a heated chamber. This 3D4Makers PAHT filament features the following properties:

    • Easy to print, low warping and increased layer adhesion
    • Excellent tensile and impact strength
    • Suitable for industrial applications

 Micro CT analysis Luvocom PAHT 9825 VS Standard PA6

Material properties

 
 
DescriptionValueTest method
Density 1,20 g/cm3 ISO 1183-3
Tensile  strength (at 23°C/50% rh) 85 MPa ISO 527
Elongation (at 23°C/50% rh)
3,6 %
ISO 527
Modulus of Elasticity  (at 23°C/50% rh) 3,4 GPa ISO 527
Heat Distortion Temp. 90 °C ISO 75
Continuous Service Temp. 120 °C UL 746B
Maximum (short term) Use Temp. 160  °C /
Thermal Conductivity 0,3 W/mK  HOT-DISK

Printer recommendations 

DescriptionValue
Printer nozzle temperature 260 - 285°C
Heated bed temperature 60 - 80°C
Print Speed 40 - 60 mm/s
Bed Adhesion Magigoo PA on glass or a PEI Sheet
Pre drying recommendations 100°C, 4 - 6 hours or 80°C, 12 hours

*Printing profile available in Ultimaker Marketplace (Ultimaker certified material)


To get the best results while printing we advise you to keep the 3D printer in a room where there is hardly any draft and/or temperature fluctuations. When the 3D printer is not being used it is important to keep filament in a bag and stored in a cool, dry and dark place until it is used again.

Contactgegevens

Openingstijden

Maandag 09:00 - 17:00

Dinsdag 09:00 - 17:00

Woensdag 09:00 - 17:00

Donderdag 09:00 - 17:00

Vrijdag 09:00 - 17:00

OP Zaterdags GESLOTEN (eventueel op afspraak)

Zondag Gesloten

 

Adres

Oudeweg 91-95 Unit: A.02/0.3
MAAK Haarlem
2031 CC Haarlem

Bellen

085-3037232

Mailen

info@multi-3dprint.nl

Multi 3D Print BV, Oudeweg 91-95 Unit A.02-03, 2031 CC Haarlem, The Netherlands
Copyright Multi-3DPRINT B.V. © 2024. All Rights Reserved.

Search